CCTV Video & Audio 6" MONOCHROME VIDEO SURVEILLANCE MONITOR with AUDIO,
Inbuilt Two Channel Switcher with adjustable Dwell, VCR Video & Audio Inputs
& Outputs. Lightweight Plastic Case, for use with Video Cameras, Quad Image
Processors, Switchers, Multiplexers, etc etc. DC powered. Use with a single or
two Video Cameras and regulated Power Supply for an INSTANT low-cost yet
effective Closed Circuit Television System.
Cat
Code: MON/SW-BW 6
MONOCHROME 6 Inch MONITOR / SWITCHER with AUDIO and VCR I/O
$ ? (Gold)
click here
for details
$121 (A) Incl Tax
$134 (B) Incl Tax
with 12 VDC 1 Amp Plug Pack + $12
DIY Plug-In installation when purchased with
Plug Pack and Cable/Adaptor Set.
6" MONOCHROME VIDEO MONITOR with
AUDIO and Inbuilt Two Channel Switcher with adjustable Dwell and VCR Video/Audio
Outputs. Lightweight Plastic Case.
~ 700 Lines Horizontal Resolution (center)
Sensitivity 0.5 to 2.0 v p-p, Negative Sync
CCIR or EIA 75 ohm Composite Video Inputs and Output, compatible with Australian
and USA TV standards
Line Level Audio Inputs and Output 1 v p-p, 10 000 ohm impedance
One input could be used for a Camera and the second input for Playback from a
VCR
INPUTS
Channel 1 and Channel 2, Video and Audio, RCA sockets
Power Supply, 2.1 x 5.5 mm socket
OUTPUTS
Video & Audio to VCR, RCA sockets
14 ~ 15 Volts DC for Cameras (an In-Line Regulator is required for each camera)
via two 2.1 x 5.5 mm sockets
CONTROLS
Front: On/Off Power Switch, Dwell, Volume
Switches: Channel 1 - 2 - Automatic Sequential Switching, 50 / 60 Hz Australian
/ USA TV standard.
Rear: Vertical Hold, Brightness, Contrast
SWITCHER
Manual Select or Automatic, Dwell adjustable 1 ~ 20 seconds
Power requirements: ~ 15 VDC, ~ 600 milliamps
when used as a 'Monitor', 2.1 x 5.5 mm socket, center = +
Power requirements: ~ 15 VDC, ~ 1.2 Amps when also used to Power 2 Cameras (up
to 250 mA each)
170 mm (W) 140 mm (H) 185 mm (D)
Weight ~ 1.3 kilograms (~ 3.5 kg³)
Plug-In
DIY AV 20 metre Cable / Adaptor Set: 20 metre AV Cable with moulded
Plugs & Socket. Two RCA Plugs & DC Plug for Camera end. Two RCA Plugs
for input device, DC Socket for Plug-Pack. Two BNC-RCA Adaptors for Camera, VCR,
Quad, Switcher, Multiplexer, Monitor, Transmitter, etc.
with 1.5m Cable & Adaptors: + $6
Dual 1.5 m Cable with two RCA Plugs each end, supplied with two BNC-RCA Adaptors
for interconnecting: Quad / Multiplexer / Monitor / VCR etc.
Use your Browser "Back
Button" to return to previous page
BUNDLED-PAKS
'exceptional value' completely DIY Plug-In installation click here
for details.
